Metal Roof Over Shingles (Retrofit) Wichita Falls

Metal Roof Over Shingles (Retrofit) in Wichita Falls

Wichita Falls sits on the rolling North Texas plains along the Wichita River, on red clay and sandy loam that shifts with every wet season, and the roofs here take a beating. Big spring hailstorms, straight-line thunderstorm winds and the occasional tornado warning punish every shingle field in the county, on top of scorching summer sun and strong south winds that work fasteners loose. Most of the housing stock in the older neighborhoods near downtown and Fairmont is 1910s to 1930s brick and frame bungalows with composition shingles that have already been re-covered once. A Metal Roof Over Shingles (Retrofit) in Wichita Falls lets you put a hail-rated metal roof directly over your existing asphalt shingles with no tear-off, less landfill waste and a lower bill than a full replacement. We check deck condition first and tell you straight when tear-off is the better call after a hail event. If you want the full picture on panel options, start with our metal roof installation page.

Why Retrofit Over Shingles Makes Sense on Wichita Falls Ranch Homes

The 1950s to 1970s brick ranches with low-pitched roofs and carports across Southwest and Northwest Wichita Falls, Burkburnett and Iowa Park are the sweet spot for a retrofit. Those low slopes shed hail poorly, and the original shingle layers are often already stacked two deep. Adding metal panels over them gives you a hail-rated surface without a dumpster in the driveway for a week.

You skip the tear-off labor and the dump fees, which is where a big share of a replacement bill hides.
You keep the existing shingles as a second water-shedding layer and an extra layer of deck protection.
You get a hail-rated metal surface that shrugs off the spring storms that hammer this corridor.
You cut the job from days to usually one or two on a typical ranch home.
You avoid the mess of stripping a roof over a finished attic or a carport ceiling.

That is why so many homeowners around Faith Village and Midwestern Parkway ask about a retrofit before they ask about a full tear-off.

Key info: Texas code limits how many layers of roofing you can stack. If your home near downtown Wichita Falls already carries two layers of shingles, a retrofit may not be legal and a tear-off is required. We check the layer count and the deck before we quote anything. Local rules vary by jurisdiction, so confirm with the City of Wichita Falls building department. See wichitafallstx.gov for current permitting.

How We Install a Metal Roof Over Shingles in Wichita Falls

We do not just screw panels to old shingles and drive off. A retrofit that lasts starts with the deck and the fastening pattern, because the same south winds that work shingle tabs loose will find a bad screw line. Here is the sequence we run on a typical Wichita Falls retrofit.

We walk the roof and check the deck for soft spots, rot and any prior storm damage.
We verify the existing layer count against code and confirm a retrofit is allowed.
We install a horizontal purlin or batten system to give the panels a true, flat plane.
We lay a high-temp underlayment over the shingles to separate the layers and shed water.
We set the panels with the correct screw pattern for our wind zone and torque them to spec.
We flash the penetrations, valleys and chimneys so the retrofit ties into the existing roof cleanly.
We clean the gutters and walk the yard for nails before we leave.

If your home is in the 76309 ZIP near the river, we can pull up the local page for that area at metal roofing in Wichita Falls 76309.

Local example: A 1962 brick ranch off Southwest Parkway had two layers of shingles and a low 3/12 slope. We checked the deck, confirmed one layer could come off legally to stay under the code limit, then retrofitted an R-panel over battens. The homeowner kept the carport ceiling intact and had a hail-rated roof in two days.

Retrofit Approaches We Use on Wichita Falls Roofs

Not every retrofit is the same. The right approach depends on your slope, your existing layer count and how much you want to spend. This table lays out the main paths we install in this market.

Approach	Description	Best for
Exposed-fastener R-panel over battens	Ribbed panels screwed through battens set over the shingles, with a high-temp underlayment between layers.	Ranch homes and shops on a budget that still want hail resistance.
Standing seam over shingles	Concealed-fastener panels on a batten system, no exposed screws to back out in the wind.	Two-story subdivision homes and owners who want a cleaner look.
Stone-coated steel over shingles	Textured steel panels that mimic shingle or tile, installed on a batten grid.	Older neighborhoods where a metal look would clash with the block.
Metal shingle retrofit	Interlocking steel shingles laid over the existing field with new underlayment.	Craftsman cottages and Tudor Revival homes near Fairmont.
Partial retrofit with tear-off	Strip the shingles on the bad slopes, retrofit the rest, and tie the two together at the ridge.	Homes with one storm-damaged slope and one sound slope.

We pick the approach after we see the deck and the layer count, not before.

Metal Roof Over Shingles (Retrofit) Cost in Wichita Falls: What to Expect

Most Wichita Falls retrofits start around $7 per square foot for an exposed-fastener panel over battens, and climb from there. The number that matters is not the headline rate, it is what your specific roof needs. A simple ranch in Iowa Park with one layer and easy access sits near the low end. A steep two-story in the Midwestern Parkway area with valleys, dormers and a chimney lands higher.

What moves the price:

Roof pitch and complexity, since steep slopes and multiple valleys slow the crew.
Deck condition, because soft spots and rot have to be repaired before panels go on.
Existing layer count, since a second layer may force a partial tear-off to stay legal.
Panel choice, because standing seam and stone-coated steel cost more than R-panel.
Access, since a tight lot near downtown means more hand-carrying and more time.
Penetrations and flashing, because chimneys, skylights and vent stacks add detail work.

Get two or three written estimates and compare the scope line by line, not just the bottom number. Our full pricing overview breaks down what each tier includes.

Metal Roof Over Shingles (Retrofit) Near Me: How to Hire a Contractor Near Wichita Falls

Anybody with a truck and a ladder can quote a retrofit. The difference shows up two summers later when the screws back out or the flashing leaks at the chimney. Use these checks before you sign.

Confirm the contractor is licensed and insured, and ask for a certificate of insurance before work starts.
Get at least two or three written estimates that spell out panel type, underlayment and fastening.
Ask for local references on retrofit jobs, not just new construction, and call them.
Ask who pulls the permit, because a re-roof usually needs one and the rules vary by jurisdiction.
Check HOA and historic district design review if you live in a protected neighborhood, since panel profile and color may be restricted.

If a contractor will not put the panel spec and the layer count in writing, keep looking. When you are ready, reach out through our contact page and we will walk the roof with you.

Metal Roof Over Shingles (Retrofit) in Wichita Falls: Pricing Guide

Service	Price	Details
Exposed-fastener R-panel retrofit	Starting at $7/sq ft	Includes battens, high-temp underlayment, panels and screws; pitch and deck condition move the price.
Standing seam retrofit over shingles	Starting at $11/sq ft	Concealed-fastener panels on battens; roof complexity and panel gauge drive the final figure.
Stone-coated steel or metal shingle retrofit	Starting at $12/sq ft	Textured panels on a batten grid; valleys, dormers and chimneys add detail labor.
Partial tear-off plus retrofit	On estimate	Needs an on-site look to confirm layer count, deck condition and how the two sections tie at the ridge.
Travel	Included	In Wichita Falls and surrounding areas, no separate call-out or mileage fee.
Estimate	Free	Response within 24 hours at (940) 400-3876, no obligation to book.

Indicative pricing, the exact cost depends on square footage, finish, and site access. Free personalized estimate within 24h at (940) 400-3876.

Metal Roof Over Shingles (Retrofit): service areas

📍 Wichita Falls 📍 Burkburnett 📍 Iowa Park 📍 Holliday 📍 Electra 📍 Henrietta 📍 Archer City 📍 Olney 📍 Bowie 📍 Nocona 📍 Seymour 📍 Vernon 📍 Jacksboro 📍 Scotland 📍 Petrolia 📍 Windthorst

Frequently asked questions: Metal Roof Over Shingles (Retrofit) in Wichita Falls

Can you put a metal roof over shingles in Wichita Falls?

Yes, in most cases. Texas code limits how many layers of roofing you can stack, so a home with one layer of shingles is usually a clean candidate and a home with two layers may need a partial tear-off first. We check the layer count and the deck condition before we quote. Homes in the older neighborhoods near downtown and Fairmont often already carry two layers, so that check matters.

How much does a metal roof over shingles cost in Wichita Falls?

Expect to start around $7 per square foot for an exposed-fastener panel over battens on a simple ranch home. Standing seam and stone-coated steel run higher, and steep two-story roofs with valleys and dormers land above the starting rate. The final number depends on deck condition, layer count, panel choice and access. Two or three written estimates will show you the real spread.

Do you have to remove the old shingles before installing metal?

Not always, and that is the point of a retrofit. We install battens and a high-temp underlayment over the existing shingles, then set the panels on top. We only recommend tear-off when the deck is soft, when the layer count exceeds what code allows, or when the shingles are failing badly enough that they will not hold the fasteners. We tell you which case you are in after we walk the roof.

How long does a metal roof retrofit take in Wichita Falls?

A typical single-story ranch home takes one to two days once materials are on site. A two-story subdivision home with valleys, dormers and a chimney usually runs two to four days. A partial tear-off plus retrofit on a storm-damaged slope can add a day. Weather delays in spring storm season can push the schedule, so we build a cushion into the start date.

Do I need a permit for a metal roof over shingles in Wichita Falls?

A re-roof commonly requires a permit, and thresholds, fees and inspection requirements vary by jurisdiction. We confirm the requirement with the City of Wichita Falls building department before work starts and pull the permit when one is needed. If your home sits in a historic district or an HOA with design review, panel profile and color may be restricted, so check that early.

What is the difference between a retrofit and a full metal roof replacement?

A retrofit installs metal panels over your existing shingles, with no tear-off and less waste. A full replacement strips the roof to the deck, repairs or replaces the deck, then installs the new roof. A retrofit costs less and goes faster, but a full replacement is the right call when the deck is soft or the layer count is maxed out. We recommend one or the other based on what the deck tells us.

What is the best time of year for a metal roof retrofit in Wichita Falls?

Late spring through early summer and early fall are the easiest windows, because the big spring hail and the straight-line thunderstorm winds have passed and the summer heat has not peaked. Summer installs are doable but crews start early to beat the heat. The failure mode that dominates here is hail and wind damage to shingles, so many homeowners schedule a retrofit right after a storm season rather than before it.

Do you handle emergency metal roof work in Wichita Falls?

Yes. If a storm has opened your roof or a panel has lifted, call (940) 400-3876 and we will get a tarp or a temporary repair in place, usually the same day or the next morning. We then assess whether the fix is a repair or a retrofit. Emergency calls get priority over scheduled work during storm season.

Is the estimate really free and no-obligation?

Yes. We walk the roof, check the deck and the layer count, and give you a written scope with a price. There is no charge for the visit and no obligation to book. We respond within 24 hours at (940) 400-3876. If a retrofit is not the right call for your roof, we will tell you that too.

Are you licensed and insured for metal roof work in Wichita Falls?

Yes. We are licensed and insured for metal roofing installation, repair and replacement in Wichita Falls and the surrounding communities. We can provide a certificate of insurance on request before work starts. Ask any contractor you consider for the same document, and confirm the coverage is current.